Skip to main content
Skip table of contents

How to pair Shelly BLU TRV with Shelly BLU Gateway Gen3

How to pair TRV to Gateway Gen3.png

  1. Insert Shelly BLU Gateway Gen3 into a standard USB-A port.

  2. Press the Pairing button on the gateway.

  3. Within the next 30 seconds, remove the isolation tab from the battery compartment of the Shelly BLU TRV.

  4. Press its Reset button on the Shelly BLU TRV. The display begins to flash Asset 1.png.

    • If the pairing is successfully completed, the Shelly BLU TRV display shows flashing confirmation Asset 2.png.

  5. Add Shelly BLU Gateway Gen3 to Shelly Smart Control by following the app’s instructions.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close