Below the Main Controls heading, observe Shelly Device as a percentage. There is a mute button for the alarm sound, and the status of whether or not gas has been detected.
If you have Shelly Device notifications, they will appear on this tab.
Observe the recorded history of the Shelly Device events. See the date, time and type of action executed such as whether or not smoke was sensed, and the Shelly Device battery as a percentage.
Use events to trigger http endpoints. For each possible condition, check the toggle button to enable the condition. Click the edit icon, and input up to 5 URLs in order to trigger http endpoints. Click the
+ Add URL button to add another URL, or click the trash icon to delete a URL. Possible conditions are:
This function requires a working connection to the Internet. More than 2 actions can affect the normal operation of the device depending on the network infrastructure and the controlled devices.
Register Shelly Device to connect to up to 2 different Wi-Fi networks. Either input or select the Wi-Fi network. Can select an open network, and also set a static IP address. Enable Wi-Fi 1, or Wi-Fi 2, or both at the same time. If both Wi-Fi 1 and Wi-Fi 2 are enabled, and Shelly Device disconnects from one of the networks, it will connect to the other.
Enable to configure Shelly Device to create a Wi-Fi AP and you can connect to its network. Can also set it to be an open network.
See outbound websocket status as Connected or Disconnected. Click the checkbox to enable SSL connectivity. Please note changing these settings requires a device reboot. Click the
SAVE button to save any changes made.
RPC over UDP
Input the destination address and port. Afterwards, input the listening port. Click the
Save button to save any changes made.
Enable to connect Shelly Device to its cloud. This allows you to control it remotely, and receive notifications and updates about your devices.
Enable to allow Bluetooth communication. Enable Bluetooth gateway.
Enable to configure Shelly Device to execute actions via MQTT.
Keep the device name in sync with the name given in the app.
Exclude From Activity Log
Click the checkbox to disable activity log reports for this device.
Input an email and share control of the Device with another Shelly Smart Control user. The other user will only have access to the Main Controls, Notifications, Charts, and Application Settings tabs, and the Device Information on the Settings tab. The other user cannot see the other device tabs. View which email accounts this Shelly Device has been shared with, and click the delete button to the right of the email account you would like to delete. If a device has been shared with your account, view which account shared it with you, and click the
Remove from my account button if you wish to delete it from your account.
Set a name for your device.
Shows your current firmware version. If a newer version is available, you can update your Shelly device by clicking the
Geo Location And Time Zone
Set your time zone and geo-location in one of three ways:
Select it manually by choosing your Time zone from the dropdown menu.
Set the daylight saving as on / off / auto.
Input your location Latitude and Longitude.
Select your location from the map by clicking
Select from mapbutton.
Enable automatic detection by clicking the
Auto detect locationbutton.
Reboot your Shelly Device.
Reset your Shelly Device to its factory settings by clicking the
Factory reset button. This will disconnect the Shelly Device from your Wi-Fi network, and all associated users, including you, will be removed from this Device. All previously set data will be deleted.
Here you can view the Shelly Device ID, IP and other device settings.