Skip to main content

Shelly Gas LPG Device Page

Status and Control

From left to right across the status and control bar, you see the Device image, name, and status. Click the power button to turn your device on/off. Directly below the status and control bar is the ppm level, and the date and time when the device was last active.

The status and control bar remains at the top of the Device page when you click on either the Status and control or Settings tab.


Observe a chart with the measured PPM levels. Above the PPM chart, you can select the time interval and the date from which you want data to be shown. Below the PPM chart you have the option to download the PPM data by clicking the DOWNLOAD button. This downloads a table of your Shelly Device PPM data.

If a firmware update is available, then you will observe a "Firmware Update Available" text below the Consumption chart. Click the UPDATE button to update your Shelly Device firmware.


Valve Control

Click the CLOSE VALVE button in order to close the valve.

Sensor Self Test

Click the SELF TEST button to run the self test.

Sensor Mute

Click the MUTE button to mute the sensor. The sensor will be muted only if the alarm is active.

I/O Actions

Use events to trigger http endpoints, and input up to 5 URLs per action. For each possible condition, select the checkbox to enable the condition. The possible conditions are:

  • Alarm off

  • Alarm mild

  • Alarm heavy

Application Settings

Exclude From Event Log

Do not show event log reports for this device in the app.

Sync Name

Keep the device name in sync with the name given in the app.



Register the Shelly device to connect to up to 2 different Wi-Fi networks. Either input or select the Wi-Fi network. Can select an open network, and also set a static IP address. Enable Wi-Fi 1, or Wi-Fi 2, or both at the same time. If both Wi-Fi 1 and Wi-Fi 2 are enabled, and the Shelly device disconnects from one of the networks, it will connect to the other.

Access Point

Enable to configure the Shelly device to create a Wi-Fi AP and you can connect to its network. Can also set it to be an open network.

Wi-Fi AP Roaming

Click checkbox to enable Wi-Fi AP roaming.

Restrict Login

Restrict the web interface of the device with a Username and Password.


Enable to connect Shelly Device to its cloud. This allows you to control it remotely, and receive notifications and updates about your devices.


Input an email and share control of the Device with another Shelly Cloud user. The other user will only have access to the Device's power button (on/off), and be able to see the Device Information. The other user cannot see the other device settings.


Eco Mode

Device will consume less energy and run at a lower temperature. Device will reboot if you disable/enable this function.


Select the alarm volume level from the dropdown menu. Choose a value from 1 to 11. Click the SAVE button to save any changes.

Firmware Update

Shows your current firmware version. If a newer version is available, you can update your Shelly device by clicking the UPDATE button.

Geo Location And Time Zone

Set your time zone and geo-location manually, or enable/disable automatic detection.

Device Name

Change the current device name. This will reflect on the device name in the application if the “Sync name” setting is enabled.

Factory Reset

Remove Shelly Device from your account and return it to its factory settings. This will delete all set data.

Device Reboot

Reboot your Shelly Device.

Device Info

Here you can view the ID, IP and other settings of your device. Upon clicking Edit device, you can change the room, name or image of the device.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.