Skip to main content

Shelly Button 1 Device Page

Status and Control

From left to right across the status and control bar, you see the Device image, and name. Directly below the status and control bar is the current room Device battery as a percentage, date and time.


I/O Actions

When Shelly Button wakes up, the following actions will be executed.

For each possible condition, check the checkbox to enable the condition. Input up to 5 URLs in order to trigger http endpoints. Set a start and end time for these actions. Possible conditions:

  • Button short push

  • Button long push

  • Button double short push

  • Button triple short push



Register the Shelly Device to connect to up to 2 different Wi-Fi networks. Either input or select the Wi-Fi network. Can select an open network, and also set a static IP address. Enable Wi-Fi 1, or Wi-Fi 2, or both at the same time. If both Wi-Fi 1 and Wi-Fi 2 are enabled, and the Shelly device disconnects from one of the networks, it will connect to the other.

Access Point

Enable to configure the Shelly device to create a Wi-Fi AP and you can connect to its network. Can also set it to be an open network. Click the APPLY button to enable access point. You will be asked if you are sure you want to proceed and click Yes / NO.

Restrict Login

Restrict the web interface of the device with a username and password. Tick Enable and type in username and password where prompted.


Enable to connect the Shelly device to its cloud. This allows you to control it remotely, and receive notifications and updates about your devices.

Application Settings

Exclude From Event Log

Do not show event log reports for this device in the app.

Sync Name

Keep the device name in sync with the name given in the app.


Input an email and share control of the Device with another Shelly Cloud user. The other user will only have access to the Device's power button (on/off), and be able to see the Device Information. The other user cannot see the other device settings.


Long Push

Set a max time (between 800 - 2000 ms) to register as a long push in milliseconds.

Multi Push

Set a max time (between 200 - 2000 ms) between pushes to register as a multi push in milliseconds.

Remain Awake

Set a time (between 0 - 5) in seconds for the button to sleep after a button push.

LED Status Disable

Disable Wi-Fi status LED.

Firmware Update

Shows your current firmware version. If a newer version is available, you can update your Shelly device by clicking the UPDATE button.

Geo Location And Time Zone

Set your time zone and geo-location manually, or enable/disable automatic detection.

Device Name

Set a name for your device.

Factory Reset

Remove Shelly Device from your account and return it to its factory settings. This will delete all set data.

Device Reboot

Reboot your Shelly Device.

Device Info

Here you can view the ID, IP and other settings of your device. Upon clicking EDIT DEVICE, you can change the room, name or image of the device.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.